D-Link DGS-510 Reference Manual page 627

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
Example
This example shows how to enable the surveillance VLAN function and configure VLAN 1001 as a
Surveillance VLAN.
Switch# configure terminal
Switch(config)# surveillance vlan 1001
Switch(config)#
68-2 surveillance vlan aging
This command is used to configure the aging time for aging out the surveillance VLAN dynamic
member ports. Use the no form of this command to revert to the default setting.
surveillance vlan aging MINUTES
no surveillance vlan aging
Parameters
MINUTES
Default
By default, this aging time is 720 minutes.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
Use this command to configure the aging time for aging out the surveillance device and the
surveillance VLAN automatically learned member ports.
When the last surveillance device connected to the port stops sending traffic, and the MAC address of
this surveillance device is aged out, the surveillance VLAN aging timer will be started. The port will be
removed from the surveillance VLAN after expiration of surveillance VLAN aging timer.
If the surveillance traffic resumes during the aging time, the aging timer will be cancelled.
Example
This example shows how to configure the aging time of surveillance VLAN to 30 minutes.
Switch# configure terminal
Switch(config)#surveillance vlan aging 30
Switch(config)#
68-3 surveillance vlan enable
This command is used to enable the surveillance VLAN state of ports. Use the no form of this
command to disable the surveillance VLAN state of ports.
surveillance vlan enable
no surveillance vlan enable
Specifies the aging time of surveillance VLAN. The range is from 1
to 65535 minutes.
624