D-Link DGS-510 Reference Manual page 252

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
28-12 port1
This command is used to specify the second ring port of a physical ring. Use the no form of this
command to remove the settings.
port1 {interface INTERFACE_ID | none}
no port1
Parameters
INTERFACE_ID
none
Default
None.
Command Mode
ERP Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
This command is used to specify or remove the first ring port of a physical ring. Use the port1 none
command to indicate that the inter-connect node is a local node endpoint of an open ring.
Example
This example shows how to configure the inter-connect node as a local end node of the G.8032 ring
"ring2".
Switch#configure terminal
Switch(config)#ethernet ring g8032 ring2
Switch(config-erp)#port1 none
Switch(config-erp)#
28-13 revertive
This command is used to revert back to the working transport entity, for example, when the RPL was
blocked. Use the no form of this command to continue using the RPL, if it has not failed and if the
'switch link defect' condition was cleared.
revertive
no revertive
Parameters
None.
Default
By default, this option is revertive.
Specifies the interface ID of the second ring port. The interface(s)
can be a physical interface or a port-channel.
Specifies that the inter-connect node is a local node endpoint of an
open ring.
249