D-Link DGS-510 Reference Manual page 122

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
Default
None.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
If the command is configured on an IPv6 ISTAP tunnel, the last 32 bits of the interface ID are
constructed using the source IPv4 address of the tunnel.
Example
This example shows how to add an IPv6 address incidence.
Switch# configure terminal
Switch(config)# interface vlan1
Switch(config-if)# ipv6 address 3ffe:501:ffff:0::/64 eui-64
Switch(config-if)#
10-4 ipv6 address dhcp
This command is used to configure an interface using DHCPv6 to get an IPv6 address. Use the no
form of this command to disable the using of DHCPv6 to get an IPv6 address.
ipv6 address dhcp [rapid-commit]
no ipv6 address dhcp
Parameters
rapid-commit
Default
None.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
Use this command to configure the interface to use DHCPv6 to get an IPv6 address. When the no
ipv6 address dhcp command is used, the previous DHCPv6 obtained IP address will be removed. If
the rapid commit keyword is specified for the command, the rapid commit option will be included in
the solicit message to request for the two-message exchange for address delegation.
Example
This example shows how to configure VLAN 1 to use DHCPv6 to get an IPv6 address.
Specifies to proceed with two-message exchange for address
delegation. The rapid-commit option will be filled in the Solicit
message to request two messages handshake.
119