D-Link DGS-510 Reference Manual page 28

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
Default
By default, this option is bidirectional mode.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
This command is only available for physical port interface configuration. If the port control is set to
force-authorized, then the port is not controlled in both directions. If the port control is set to auto,
then the access to the port for the controlled direction needs to be authenticated. If the port control is
set to force-unauthorized, then the access to the port for the controlled direction is blocked.
Suppose that port control is set to auto. If the control direction is set to both, then the port can receive
and transmit EAPOL packets only. All user traffic is blocked before authentication. If the control
direction is set to in, then in addition to receiving and transmitting EAPOL packets, the port can
transmit user traffic but not receive user traffic before authentication.
Example
This example shows how to configure the controlled direction of the traffic through Ethernet eth1/0/1
as unidirectional.
Switch# configure terminal
Switch(config)# interface eth1/0/1
Switch(config-if)# dot1x control-direction in
Switch(config-if)#
3-3 dot1x default
This command is used to reset the IEEE 802.1X parameters on a specific port to their default settings.
dot1x default
Parameters
None.
Default
IEEE 802.1X authentication is disabled.
Control direction is bidirectional (both).
Port control is auto.
Forward PDU on port is disabled.
Maximum request is 2 times.
Server timer is 30 seconds.
Supplicant timer is 30 seconds.
Transmit interval is 30 seconds.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12.
25