Using Multi Operations; Using System Off; Erasing All The Settings For The Multi- Operation - Pioneer VSX 1020 Operating Instructions Manual

Controlling the rest of your system
5 Repeat steps 3 to 4 to program a
sequence of up to five commands.
If you press R.SETUP before programming is
completed, commands programmed up to that
point will be stored.
6 Press R.SETUP to exit the programming
mode.

Using multi operations

1 Press MULTI OPERATION.
The LED flashes continuously.
2 Within five seconds, press an input
function button that has been set up with a
multi operation.
The receiver switches on (if it was in standby)
and the programmed multi operation is
performed automatically.
Note
1 In order to avoid accidently switching off a DVD recorder that is currently recording, no DVD recorder power off codes
are sent.

Using System off

1 Press MULTI OPERATION.
The LED flashes continuously.
Within five seconds, press  SOURCE.
2
The command sequence you programmed will
run, then all Pioneer components will switch
1
off , followed by this receiver (switch of all the
zones becomes off).
Erasing all the settings for the multi-
operation
This erases all the settings programmed in the
remote control for the multi-operation.
1 Press and hold the R.SETUP, press "8" for
three seconds.
The LED flashes continuously.
• To cancel the preset setup mode press
R.SETUP.
2 Press the input function button
containing the program you want to cancel or
the  SOURCE button for three seconds.
If the LED lights for one second, the erasing
has been successfully completed.
09
81
En