Erasing All Learnt Settings That Are In One Input Function; Direct Function - Pioneer VSX 1020 Operating Instructions Manual

Controlling the rest of your system
Erasing all learnt settings that
are in one input function
This operation erases all the operational
settings of other devices that have been
programmed in one input function, and
restores the factory default.
This function is handy for erasing all data
programmed for devices no longer being used.
1 Press and hold the R.SETUP, press "9" for
three seconds.
The LED flashes continuously.
• To cancel the preset setup mode press
R.SETUP.
2 Press and hold the input function button
corresponding to the command to be erased
for three seconds.
If the LED lights for one second, the erasing
has been successfully completed.

Direct function

• Default setting: On
You can use the direct function feature to
control one component using the remote
control while at the same time, using your
receiver to playback a different component.
This could let you, for example, use the remote
control to set up and listen to a CD on the
receiver, and then use the remote control to
rewind a tape in your VCR while you continue
to listen to your CD player.
When direct function is on, any component you
select (using the input function buttons) will be
selected by both the receiver and the remote
control. When you turn direct function off, you
can operate the remote control without
affecting the receiver.
1 Press and hold the R.SETUP, press "5" for
three seconds.
The LED flashes continuously.
• To cancel the preset setup mode press
R.SETUP.
2 Press the input function button for the
component you want to control.
3 Press "1" (On) or "0" (Off) to switch direct
function.
If the LED lights for one second, the setting has
been successfully completed.
If the LED flashes three times to indicate, the
setting has failed.
4 Press R.SETUP to exit the setup.
09
79
En