Multi Operations - Pioneer VSX-909RDS Operating Instructions Manual

Using Other Functions

Multi Operations

A Multi Operation is a sequence of commands programmed into a single button to save you a lot of repetitive
button pressing. Once setup, pressing the MULTI OPERATION button followed by one of the MULTI CONTROL
buttons will switch on that component, the receiver and your TV, and switch the function of the receiver to that
component. Up to five more commands can be programmed into a Multi Operation, such as changing the sound
mode of the receiver and starting playback of the source.
Important: For Multi Operations to work with other non-Pioneer components, you must first setup the remote to
control those other components—see pages 65-68 for more on this.
Î
S0URCE
MULTI
OPERATION
DVD/LD TV/SAT
MULTI CONTROL
MD/
CD TUNER
TAPE1
CLASS MPX
¶ 7
- +
TUNING
1 ¡ 4
1 2
4 5
7 8
0
+10
RF ATT
+
TV
TV VOL TV CONTROL
–
TV FUNC
REMOTE SETUP
2
INPUT
MENU
ATT
SYSTEM SETUP
+
EFFECT/
CH SEL
ENTER
DIGITAL
–
NR
MULTI CH
MIDNIGHT
INPUT
/DTS/MPEG
ADVANCED
LIGHT THX
AV PRE-PROGRAMMED AND LEARNING
REMOTE CONTROL UNIT
78
En
1 1 Set the remote control slide switch to
USE SETUP
RECEIVER
SYSTEM
OFF
VCR1 VCR2
3,4
TVCONT
BAND DIRECT ACCESS
3 8
2 Press the REMOTE SETUP button (INPUT
- +
STATION
¢
- +
CHANNEL
2
3
6
9
DISC
DISPLAY
+
VOLUME
–
MUTE
FUNCTION
SIGNAL
SELECT
STEREO/
DSP
DIRECT
STANDARD
3 Select a MULTI CONTROL button for this
4 Select the MULTI CONTROL button for a
SETUP.
Also make sure that your TV is on and set to the receiver.
ATT) and at the same time to select the
3
MULTI OPERATION SETUP mode.
The REMOTE SETUP menu appears on your TV screen. The
MULTI CONTROL and the SYSTEM OFF buttons start to blink
(see the following page for more on the SYSTEM OFF button).
Multi-operation
1Select an item from the
Multi-Contorol buttons.
(ex. DVD)
2Select the operation
button. (ex. DVD = MENU)
3First command has been
learned.
4You can repeat this
proccess for 5 commands.
EXIT = Remote Setup
• To cancel here, press REMOTE SETUP.
MULTI OPERATION.
Each MULTI CONTROL button can be used for one Multi
Operation. If a Multi Operation relates to using a DVD player,
for example, it makes sense to select the DVD/LD button.
After pressing a MULTI CONTROL button, just that button will
remain blinking.
source component.
For example, if you want this Multi Operation to switch on your
DVD player press the DVD/LD.
After pressing a MULTI CONTROL button, that button stays lit.