Using Multi Operations - Pioneer VSX-9300TX Operating Instructions Manual

Controlling other equipment
08
4 Use (cursor up/down) to select a command
in the sequence then press ENTER.
If this is the first command in the sequence, select 1st
Cmmnd. Otherwise, simply choose the next command in
the sequence.
5 To add (or change) a command select 'Change'
and press ENTER.
Function flashes in the display.
• To erase a command select Clear and press ENTER.
You will return to the last step.
• To go back a step, select *Exit* and press ENTER.
6 Press the MULTI CONTROL button for the
component whose command you want to input.
Key flashes in the display.
7 Select the button for the command you want to
input.
The following remote control commands can be
selected:
• After selecting a command, COMPLETE appears in
the display.
60
En
SOURCE TV
DIMMER LOUDNESS TONE EFFECT/CH SEL
1 2 3 4
+
SIGNAL SEL DNR BASS/TREBLE
5 6 7 8
+10
VIDEO SEL HI-BIT DISC
9 0
ENTER
DIRECT ACCESS SEARCH MODE
SYSTEM SETUP GUIDE
MENU TOP MENU
TUNER EDIT TRACK
ENTER
EXIT
AUDIO RETURN
MPX
DTV ON/OFF DISP MODE
SUB TITLE
+
TUNING BAND TUNING
+
STATION DTV MENU CLASS STATION
+
CHANNEL CHANNEL
+ TV INPUT
TV CONTROL
+
TV VOL MIDNIGHT
TV CH
MULTI DH
INPUT
STEREO/ SB CH
DIRECT MODE
8 Repeat steps 4–7 to program a sequence of up to
five commands.
• You don't need to program the receiver to switch on
or off. This is done automatically.
With Pioneer components, you don't need to:
• program the power to switch off in a shutdown
sequence;
• program the power to switch on if it's the source
component selected in step 3;
• program a Pioneer TV or monitor to switch on if the
input function (selected in step 2) has video input
terminals;
These take priority in multi operations (not shutdown).
9 When you're finished, use
to select '*Exit*' from the menu and press ENTER.
You will return to the REMOTE SETUP menu. Select
*Exit* again to exit.

Using multi operations

You can start multi operations with the receiver switched
on, or in standby.
DVD/LD TV/SAT
MULTI CONTROL
VCR2 VIDEO
CD-R/ MD/
TAPE1 TAPE2
1 Press MULTI OPERATION.
Select Function flashes in the display.
2 Press a function button that has been set up with
a multi operation.
The receiver switches on (if it was in standby) and the
programmed multi operation is performed automatically.
(cursor up/down)
VCR1 /
TV CONT
DVR
MULTI
CD
OPERATION
TUNER