Using Multi Operations; Using System Off; Controls For Tvs - Pioneer VSX-LX60 Operating Instructions Manual

Controlling the rest of your system
Use / to select a command in the sequence then
5
press ENTER.
If this is the first command in the sequence, select 1ST
CODE. Otherwise, simply choose the next command in
the sequence. PRES KEY flashes after you press ENTER.
6 If necessary, press the input source button for the
component whose command you want to input.
This is only necessary if the command is for a new
component (input source).
7 Select the button for the command you want to
input.
The following remote control commands can be selected:
SYSTEM OFF
INPUT
RECEIVER SOURCE
SELECT
CD CD-R HDMI
DVD TV BD TV CTRL
HOME MEDIA
DVR2 ZONE2/3
GALLERY
DVR1 i Pod TUNER RECEIVER
SLEEP DIMMER ANALOG
ATT
SR+ GENRE
D.ACCESS CLASS
DISC
CLEAR
+10
CH ENTER
LEVEL
A PARAMETER V PARAMETER
ì
TOP MENU MENU T.EDIT
TUNE
BAND ST ST
ì ì
ENTER
RETURN
SETUP
TUNE
PROGRAM
PTY SEARCH GUIDE
TV CONTROL
• You don't need to program the receiver to switch on
or off. This is done automatically.
With Pioneer components, you don't need to:
• program the power to switch off in a shutdown
sequence (except DVD recorders);
• program the power to switch on if it's the source
component selected in step 3;
• program a Pioneer TV or monitor to switch on if the
input function (selected in step 2) has video input
terminals;
These take priority in multi operations (not shutdown).
8 Repeat steps 5–7 to program a sequence of up to
five commands.
When you're finished, use / to select EDITEXIT
9
from the menu and press ENTER.
You will return to the remote control SETUP menu. Select
* EXIT * again to exit.
Note
1 In order to avoid accidently switching off a DVD recorder that is currently recording, no DVD recorder power off codes are sent.
PTY SEARCH
TV CONTROL
INPUT
VOL
TV VOL TV CH
SELECT
REC INFO
TV/DTV
A
MUTE
MPX EON REC STOP JUKEBOX
B C D E
AUDIO SUBTITLE HDD DVD
DISP CH CH
PHOTO T.DISP
STEREO/
STATUS SIGNAL SEL SBch F.S.SURR

Using multi operations

You can start multi operations with the receiver switched
on, or in standby.
PHOTO
STATUS STATUS SIGNAL SEL
MULTI OPE THX
SHIFT
PHASE
RECEIVER
1 Press MULTI OPE.
MULTI OP flashes in the display.
2 Press an input source button that has been set up
with a multi operation.
The receiver switches on (if it was in standby) and the
programmed multi operation is performed automatically.

Using System off

SYSTEM OFF
RECEIVER INPUT SOURCE
SELECT
CD CD-R HDMI
DVD TV BD TV CTRL
HOME MEDIA
1 Press MULTI OPE.
MULTI OP flashes in the display.
2 Press SOURCE.
The command sequence you programmed will run, then
all Pioneer components will switch off
receiver.

Controls for TVs

This remote control can control components after
entering the proper codes or teaching the receiver the
commands (see Setting the remote to control other
components on page 76 for more on this). Use the input
source buttons to select the component.
T.DISP
STEREO/
SBch F.S.SURR
STANDARD ADV. SURR
MCACC S.DIRECT
PHOTO T.DISP
STEREO/
STATUS STATUS SIGNAL SEL SBch F.S.SURR
MULTI OPE THX STANDARD ADV. SURR
SHIFT
PHASE MCACC S.DIRECT
RECEIVER
1
, followed by this
13
79
En