Reducing The Level Of An Analog Signal; Using The Sleep Timer; Dimming The Display; Switching The Speaker Impedance - Pioneer VSX-LX60 Operating Instructions Manual

Using other functions
1 During recording, press the REC SELECT CONTROL
button on the front panel until RECOUT shows in the
1
display.
2 While RECOUT shows in the display, use the
INPUT SELECTOR dial to select the source you want
to record.
The default, RECOUT SOURCE, records the source you're
currently listening to (as in Press RETURN to confirm and
exit the menu. above).
• Note that the setting you make here is stored in
memory, even if you switch off the receiver, so if you
want to record a different input source later, you
must do so with REC SELECT, or by selecting
RECOUT SOURCE.
3 After RECOUT disappears from the display, select
the input source you want to listen to.
This will be heard from the main system without affecting
2
your recording.

Reducing the level of an analog signal

The input attenuator lowers the input level of an analog
signal when it's too strong. You can use this if you find
the that the OVER indicator is lights often, or you can
hear distortion in the sound.
SLEEP
SR+
D.ACCESS
• Press ANALOG ATT to switch the input attenuator
on or off.

Using the sleep timer

The sleep timer switches the receiver into standby after a
specified amount of time so you can fall asleep without
worrying about the receiver being left on all night. Use
the remote control to set the sleep timer.
SLEEP
SR+
D ACCESS
• Press SLEEP repeatedly to set the sleep time.
30 min
Off
Note
1 If RECOUT does not appear in the display, you may have to switch ZONE 2 off by pressing MULTI ZONE & SOURCE ON/OFF and selecting either
ZONE 3 or off (the MULTI-ZONE indicator disappears). See Using the MULTI-ZONE controls on page 60 for more on this.
2 If RECOUT SOURCE is selected, changing the input source likewise changes the input source used for your recording.
3 The attenuator isn't available with digital sources, or when using the Stream Direct modes.
4 You can also switch off the sleep timer simply by switching off the receiver.
3
DIMMER ANALOG
ATT
GENRE
CLASS
SC
DIMMER ANALOG
ATT
GENRE
CLASS
60 min
90 min
• You can check the remaining sleep time at any time
by pressing SLEEP once. Pressing repeatedly will
cycle through the sleep options again.

Dimming the display

You can choose between four brightness levels for the
front panel display. Note that when selecting sources, the
display automatically brightens for a few seconds.
SLEEP
SR+
D.ACCESS
• Press DIMMER repeatedly to change the brightness
of the front panel display.

Switching the speaker impedance

We recommend using speakers of 8 Ω with this system,
but it is possible to switch the impedance setting if you
plan to use speakers with a 6 Ω impedance rating.
With the receiver in standby, press  STANDBY/
1
ON while holding down the SETUP button.
Select SPEAKER using /, then select 8 Ω or 6 Ω
2
using /.
• SPEAKER 6 Ω – Use this setting if your speakers are
rated at 6 Ω.
• SPEAKER 8 Ω – Use this setting if your speakers are
rated at 8 Ω or more.
4
DIMMER ANALOG
ATT
GENRE
CLASS
12
73
En