Usb Interface (Vsx-Lx60 Only); Ipod Messages - Pioneer VSX-LX60 Operating Instructions Manual

14 Additional information

USB interface (VSX-LX60 only)

Symptom
USB mass storage device is not
recognized by the receiver.
USB ERR3 shows in the display
when connecting a USB device.
Can't play audio files.

iPod messages

Symptom
Error I1
Error I2
No Music Track
Loading Error
Note
• If the unit does not operate normally due to external effects such as static electricity disconnect the power plug
from the outlet and insert again to return to normal operating conditions.
88
En
Remedy
• Try switching the receiver off, then on again.
• Make sure you have completely inserted the USB connector to this receiver.
• Check that the memory format is FAT16 or FAT32 (FAT12, NTFS and HFS are not supported).
• USB devices with an internal USB hub are not supported.
• If this message continues to appear after going through all the checks in Important on page 35 of USB
playback, take the unit to your nearest Pioneer authorized service center or your dealer for servicing.
• The WMA or MPEG-4 AAC files were recorded using DRM (digital rights management), or the bit rate/
sampling rate is not compatible (see Compressed audio compatibility on page 35). This is not a
malfunction.
Cause
There is a problem with the signal path from the
iPod to the receiver.
The software version being used with the iPod
needs to be updated.
There are no playable songs currently stored in
the iPod.
There is no responce from the iPod.
Action
Switch off the receiver and reconnect the iPod to the receiver.
If this doesn't seem to work, try resetting your iPod.
Update the software being used with the iPod (please use the
latest iPod software versions later than the iPod updater 2004-
10-20).
Input some music files compatible with iPod playback.
Update the software being used with the iPod (please use the
latest iPod software versions later than the iPod updater 2004-
10-20).