Installing A Hard-Drive Blank; Removing A Hot-Swap Hard Drive; Installing A Hot-Swap Hard Drive - Fortinet FortiAnalyzer-2000B Rack And Hardware Install Manual

Installing a Hard-Drive Blank

Removing a Hot-Swap Hard Drive

Installing a Hot-Swap Hard Drive

24
Figure 1: Removing and Installing a Hard Drive Blank
1
3
1 3.5-in hard drive blank
3 release latch
Align the hard-drive blank with the drive bay and insert the blank into the drive bay until the
release lever clicks into place.
Caution: Ensure that your operating system supports hot-swap drive removal and
installation. See the documentation provided with your operating system for more
information.
1 If present, remove the front bezel. See
2 From the RAID management software, prepare the drive for removal. Wait until the
hard-drive indicators on the drive carrier signal that the drive can be removed safely.
See your SAS RAID controller documentation for information about hot-swap drive
removal.
If the drive has been online, the green activity/fault indicator will flash as the drive is
powered down. When the drive indicators are off, the drive is ready for removal.
3 Press the button on the front of the drive carrier and open the drive carrier release
handle to release the drive. See Figure 2.
4 Slide the hard drive out until it is free of the drive bay.
5 Insert a drive blank in the vacated drive bay. See
6 If applicable, install the bezel. See
Caution: When installing a hard drive, ensure that the adjacent drives are fully installed.
Inserting a hard-drive carrier and attempting to lock its handle next to a partially installed
carrier can damage the partially installed carrier's shield spring and make it unusable.
2
3
2 2.5-in hard drive blank
"Installing the Bezel" on page
"Installing the Bezel" on page
FortiAnalyzer-2000B Version 4.0 MR1 Rack and Hardware Install Guide
Installing Hard Drives
18.
"Installing a Hard-Drive Blank".
18.
http://docs.fortinet.com/
Revision 1
• Feedback