Fortinet FortiAnalyzer-2000B Rack And Hardware Install Manual page 17

Rack Installation Instructions
FortiAnalyzer-2000B Version 4.0 MR1 Rack and Hardware Install Guide
Revision 1
http://docs.fortinet.com/ • Feedback
Figure 9: Installing and removing the Cable Management Arm Tray
5
• To remove the tray, squeeze the latch-release buttons on both sides toward the
center and pull the tray out of the receiver brackets (5).
3 To install and remove the CMA, do the following:
Note: You can attach the CMA to either the right or left mounting rail, depending on how
you intend to route cables from the system. Mounting the CMA on the side opposite of the
power supplies is recommended; otherwise, the CMA must be disconnected in order to
remove the outer power supply. You must remove the tray before removing the power
supplies.
• At the back of the system, fit the latch on the front end of the CMA on the innermost
bracket of the slide assembly until the latch engages (6).
4
Cable Management Arm Installation
15