Furuno FMD-3200 Installation Manual page 67

Fabrication of TTYCS cable
100 or more
Vinyl tape
Clamp here by cable clamp.
Fabrication of TTYCSLA cable
Sheath
100 or more
Vinyl tape
Wiring for WAGO connector
Wire WAGO driver
Twist
Procedure
1. Twist the conductor.
2. Press the terminal opener downward.
3. Insert the wire to hole.
4. Remove the terminal opener.
5. Pull the wire to confirm that is ecure.
• Connectors J3/J4 on the I/O Board in the processor unit can be set to IEC61162-1
or 2. This console is shiped with the setting for IRC61162-2.
• The connector J11 on the I/O Board in the processor unit can be set to the contact
input or digital input. This console is shipped with the setting for the contact input.
Armor
100
30
After exposing cores, wind
shield around the armor.
6
70
100
5
5
6
Clamp here by cable clamp.
WAGO
connector
Shield
Drain wire
Pass the drain wire through the shrink tube
(local supply), then attach the crimp-on lug
supplied in the console.
WAGO driver
Terminal board
(at the bottom of the console)
3. ECN-303/304 (OPTION)
3-5