Furuno FMD-3200 Installation Manual page 55

8. Unfasten three bolts to remove the cable clamp (upper) as shown below.
J5 J5 J8 J8
J3 J3
J12 J12
J6 J6 J9 J9
J11 J11
J4 J4
J14 J14
J7 J7 J13 J13
J10 J10
Loosen this bolt to use Loosen this bolt to use
the lower clamp holes. the lower clamp holes.
Loosen these three bolts to remove the upper plate.
9. Disconnect the control unit cable from the processor unit, then connect the cable
assy (6TPSH-XH12X2-LxxSP1).
10. Set the shield part of cables under the cable clamp then tighten the cable clamp.
11. Attach the processor unit cover.
Clamp holes
(upper)
Clamp holes
(lower)
Lay shields of cables
under this clamp then
tighten the clamp.
2. WIRING
2-35