Furuno FMD-3200 Installation Manual page 60

2. WIRING
2.6.1 Jumper settings for RCB-002
The RCB-002 is compatible with the following radars.
Maker
FURUNO*
Change the jumper settings on the RA/IF board (24P0140) according to the radar to
be connected, referring the tables on the next page. For details of the values for each
jumper block on the RA/IF board (24P0140), see "RA/IF BOARD JUMPER
VALUES" on page AP-8.
Note: According to the shipment time, the heat dispersion sheet may be attached to
the RA/IF board (24P0140). If the heat dispersion sheet is attached, it may come loose
when removing the RCB-002 cover. Before closing the cover, make sure the disper-
sion sheet is in the location shown below. If the sheet is loose, align it with the locator
lines printed on the board.
2-40
Model
• FAR-14 7 series
• FAR-2 7 series
• FAR-2 5 series
• Model 1835
Jumper locations on the RA/IF board (24P0140)
J14
J3
J16
J15
J17
J18
J19
J20
J21
J22
J23
J24
Heat dispersion sheet locator lines
Heat dispersion sheet
Maker
Japan Radio Company
(JRC)
Tokyo Keiki Inc.
*: FURUNO radars are only compatible with the
CH2 (RADAR SIGNAL IN NO.2 port).
J1 J2
J4
J5 J6
J7
J8
J9 J10
J11
J12
J13
Model
JMA-9100 series
BR-3440 series