Furuno FMD-3200 Installation Manual page 57

5. Fasten the shield part of the cable assy with the cable clamp (removed at step 2),
then connect the connector at the end of the cable assy to the J1 on the control
unit board.
Note: When clamping, the shield part of the cable must not touch the circuit board.
Cable assy
6. Reattach the control unit cover.
7. Unfasten four screws (M4x8) to remove the processor unit cover.
8. Unfasten three bolts to remove the cable clamp (upper) as shown below.
J8 J8
J5 J5
J3 J3
J12 J12
J9 J9
J6 J6
J11 J11
J4 J4
J14 J14
J7 J7 J13 J13
J10 J10
Loosen this bolt to use Loosen this bolt to use
the lower clamp holes. the lower clamp holes.
Loosen these three bolts to remove the upper plate.
9. Disconnect the control unit cable from the processor unit, then connect the cable
assy (6TPSH-XH12X2-LxxSP2).
Shield part
Cable clamp
Board
Clamp holes
(upper)
Clamp holes
(lower)
2. WIRING
2-37