Cylinder Head - Skoda FABIA 2000 Workshop Manual

FABIA 2000 1.4/55; 1.4/74 Engine - Mechanical Components
15 – Cylinder Head, Valve Gear
15-1 Removing and installing

cylinder head

Note
♦
When installing a replacement cylinder head, all the
contact surfaces between the hydraulic supporting el-
ements, roller rocker arms and the cams must be oiled
before installing the cylinder head cover.
♦ Do not remove the plastic bases supplied as a protec-
tion for the open valves until just before fitting on the
cylinder head.
♦
After replacing the cylinder head, all the coolant must
be replaced ⇒ Chapter 19-1.
Engines with engine identification characters AUA, AUB, BBY, BBZ.
1 - Top toothed belt guard
2 - Main drive-toothed belt
before removing mark run-
ning direction
check for wear
do not kink
removing and installing, ten-
sioning ⇒ Chapter 13-1
3 - Coupling drive-toothed belt
before removing mark run-
ning direction
check for wear
do not kink
removing and installing, ten-
sioning ⇒ Chapter 13-1
4 - 10 Nm + torque a further
turn (90 °)
replace
Tighten crosswise from the
middle outwards
5 - Ignition lead guide
for engines with the engine
codes AUA, AUB
6 - Non-return valve
only engines BBY, BBZ
7 - From air filter
only engines BBY, BBZ
8 - Cylinder head cover
removing and installing
⇒ 15-1 page 4
9 - 10 Nm
10 - Fit pin
11 - Roller rocker arm
inspect roller bearings of roller for smooth operation
oil contact surfaces
Edition 05.05
S00.5306.06.20
1 /
4
Removing and installing cylinder head
15
15-1 1
page