Exhaust Manifold, Front Exhaust Pipe With Pre-Catalytic Converter And Catalyst And Component Parts - Engine With Engine Identification Characters Bky - Skoda FABIA 2000 Workshop Manual

FABIA 2000 1.4/55; 1.4/74 Engine - Mechanical Components
Exhaust manifold, front exhaust pipe with pre-catalytic converter and catalyst and
component parts - Engine with engine identification characters BKY
1 - Hot air collector/shield
2 - 10 Nm
3 - Exhaust manifold
4 - Gasket
replace
5 - 25 Nm
replace
Coat stud bolts of exhaust
manifold with hot bolt paste
-G 052 112 A3-
6 - 40 Nm
replace
Coat stud bolts of exhaust
pipe with hot bolt paste
-G 052 112 A3-
7 - Lambda probe downstream of
catalytic converter -G130-, 50
Nm
only coat the thread with hot
screw paste -G 052 112 A3-;
the paste must not get into
the slot of the probe body
4-pin connector
8 - Front exhaust pipe
with pre- and main catalytic
converter
protect against shocks and
blows
9 - Clamping sleeve
Before tightening, align the
exhaust system in cold con-
dition free of stress
Fitting position: ends of the screw must not protrude beyond the bottom edge of the clamping sleeve, bolted
connection must point to the left.
Tighten bolted connections evenly
10 - 25 Nm
11 - Front tunnel bridge
12 - 23 Nm
13 - Retaining strap
replace if damaged
14 - Lambda probe upstream of catalytic converter -G39-, 50 Nm
only coat the thread with hot screw paste -G 052 112 A3-; the paste must not get into the slot of the probe
body
6-pin connector
15 - 20 Nm
16 - 40 Nm
17 - Bracket
attached to engine block
18 - Holder for wiring loom
Edition 05.04
S00.5306.05.20
Removing and installing parts of the exhaust system
26
26-1 3
page