Power Cord Caution; Cleaning The Unit - Pioneer 915 Operating Instructions Manual

13 Additional information
• FM Tuner Section
Frequency Range . . . . . . . . 87.5 MHz to 108 MHz
Usable Sensitivity . . . . . . . . . .Mono:13.2 dBf, IHF
50 dB Quieting Sensitivity . . . . . . . Mono: 20.2 dB
Signal-to-Noise Ratio . . . Mono: 73 dB (at 85 dBf)
Distortion . . . . . . . . . . . . . . . Stereo: 0.5 % (1 kHz)
Alternate Channel Selectivity. . . . . . . . . . . . 60 dB
Stereo Separation . . . . . . . . . . . . . . . 40 dB (1 kHz)
Frequency Response . . . . . . . . . . 30 Hz to 15 kHz
Antenna Input (DIN) . . . . . . . . . 75 Ω unbalanced
AM Tuner Section
Frequency Range . . . . . . . . 530 kHz to 1,700 kHz
Sensitivity (IHF, Loop antenna) . . . . . . . 350 µV/m
Signal-to-Noise Ratio . . . . . . . . . . . . . . . . . . 50 dB
Antenna . . . . . . . . . . . . . . . . . . . . . . Loop antenna
Miscellaneous
Power requirements . . . . . . . . . . . AC 120V / 60Hz
Power consumption . . . . . . . . . . . . 360W / 480 VA
In standby . . . . . . . . . . . . . . . . . . . . . . . . . 0.5 W
Dimensions . . .16
420 (W) x 158 (H) x 402.5 (D) mm
Weight (without package) . . . . . . 22.4 lb (10.2 kg)
Furnished Parts
Microphone (for Auto MCACC setup). . . . . . . . . 1
Dry cell batteries (AA size IEC R6)
Remote control . . . . . . . . . . . . . . . . . . . . . . . . . . 1
AM loop antenna . . . . . . . . . . . . . . . . . . . . . . . . . 1
FM wire antenna . . . . . . . . . . . . . . . . . . . . . . . . . . 1
Warranty card . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1
These operating instructions
Note
• Specifications and the design are subject
to possible modifications without notice,
due to improvements.
74
En
(1.3 µV/ 75 Ω)
Stereo: 38.6 dBf
Stereo: 70 dB (at 85 dBf)
(400 kHz)
9 1 7
/ (W) x 6 / (H) x 15 /
16 4
. . . . . . . . . . 2

Power cord caution

Handle the power cord by the plug. Do not pull
out the plug by tugging the cord and never
touch the power cord when your hands are wet
as this could cause a short circuit or an electric
shock. Do not place the unit, a piece of
furniture, etc., on the power cord, or pinch the
cord. Never make a knot in the cord or tie it
with other cords. The power cords should be
routed such that they are not likely to be
stepped on. A damaged power cord can cause
(±1 dB) a fire or give you an electrical shock. Check the
power cord once in a while. When you find it
damaged, ask your nearest Pioneer authorized
service center or your dealer for a replacement.

Cleaning the unit

• Use a polishing cloth or dry cloth to wipe
off dust and dirt.
• When the surface is dirty, wipe with a soft
cloth dipped in some neutral cleanser
diluted five or six times with water, and
(D) in.
8
wrung out well, and then wipe again with a
dry cloth. Do not use furniture wax or
cleansers.
• Never use thinners, benzine, insecticide
sprays or other chemicals on or near this
unit, since these will corrode the surface.