Playing Other Sources; Selecting The Multichannel Analog Inputs; Using The Sleep Timer - Pioneer 915 Operating Instructions Manual

06 Listening to your system

Playing other sources

RECEIVER
DVD/LD
1 Turn on the power of the playback
component.
2 Turn on the power of the receiver.
3 Select the source you want to playback.
Use the MULTI CONTROL buttons (or INPUT
1
SELECT).
4 Start playback of the component you
selected in step 1.
Selecting the multichannel
analog inputs
If you have connected a decoder or a DVD
player with multichannel analog outputs to this
receiver (page 18), you can select them for
surround sound playback.
STANDARD
LISTENING MODE
Note
1 If your source is the TV's built-in tuner, switch to the channel you want to watch, otherwise make sure that the TV's video input
is set to this receiver (For example, if you connected this receiver to the VIDEO 1 jacks on your TV, make sure that the VIDEO 1
input is selected). Turn down the volume of your TV so that all the sound is coming from the speakers connected to this receiver.
2 • When playback from the multichannel inputs is selected, you can't use ACOUSTIC CAL EQ, DIALOG E, INPUT ATT, TONE,
VSB and MIDNIGHT/LOUDNESS, as well as any of the listening modes (including STEREO/DIRECT and the Extended mode).
• When playback from the multichannel inputs is selected, only the volume and channel levels can be set.
• You can't listen to your speaker B (Second Zone) system during playback from the multichannel inputs.
3 You can also switch off the sleep timer simply by switching off the receiver.
42
En
INPUT
SOURCE
SELECT
TV/SAT DVR/VCR TV CONT
MULTI CONTROL
CD CD-R/TAPE TUNER RECEIVER
2
ADVANCED ST/DIRECT SIGNAL
SURR /AUTO SURR SELECT
1 Make sure you have set the playback
source to the proper output setting.
For example, you might need to set your DVD
player to output multichannel analog audio.
2 Press DVD/LD.
3 Press SIGNAL SELECT to select the
multichannel analog inputs.
DVD 5.1ch will show in the display and the
ANALOG SIGNAL SELECT indicator will light.

Using the sleep timer

The sleep timer switches the receiver into
standby after a specified amount of time so you
can fall asleep without worrying about the
receiver being left on all night. Use the remote
control to set the sleep timer.
RECEIVER CONTROL
STANDARD ADV.SURR
MIDNIGHT/
LOUDNESS DIALOG E
EFFECT
SHIFT
/CH SEL
• Press SLEEP repeatedly to set the sleep
time.
30 min
Off
• You can check the remaining sleep time at
any time by pressing SLEEP once. Pressing
repeatedly will cycle through the sleep
3
options again.
CH CH
STEREO SLEEP
ACOUSTIC
EQ INPUT ATT
LEVEL
60 min
90 min