CNI2 Operating and Installation Guide
CONFIGURING THE CNI2'S CALL INFORMATION
Go back to the device configuration screen and select the Call Information tab. Proper
configuration of the call information fields are essential to ensure that data will be collected and
available for processing when expected. If the CNI2 is programmed to originate calls only then
it will not be possible to initiate outbound calls since the cellular radio is not powered to receive
incoming calls.
Call Information Screen
The Dial Out phone number is what DC-2009 will use to call the CNI2. This might be used for a
direct CSD call ("mobile-terminate") or it may be used to "page" the unit, which will cause the
unit to call back to the system. In either case this is usually the mobile phone number that was
assigned to the cellular account. This field is automatically loaded whenever the CNI2 calls in to
report a UNIT RESET alarm.
The Target Phone Number is for record keeping only and does not affect the operation of DC-
2009. This is the phone number or IP address that was programmed into the CNI2 and is what
the CNI2 uses when placing a CSD call or making an Internet connection.
130