Leds After Over-The-Air Reprogramming - Honeywell CNI2 Operating And Installation Manual

CODE
61 Not used
62 Not used
63 Not used
64 Not used
65 Not used
66 Not used
67 Not used
68 Not used
69 Not used
71 Configuration memory has not been programmed or is corrupt. Attempt to
reload the configuration. This could be caused by a nearly-depleted battery.
Otherwise the FLASH memory in the processor is defective.
72 There is a data retention or communications problem with the non-volatile
EEPROM memory device.
73 Could not write into FLASH memory. This is a problem with the processor.
74 Over-the-air firmware download was aborted. This is usually a network-
related problem or problems with the the data collection system data
collection system.
75 The watchdog timer expired and generated a reset. This could be caused
by defective firmware but might also be caused by a defective crystal.
76 Not used
77 Not used
78 Not used
79 Not used

LEDS AFTER OVER-THE-AIR REPROGRAMMING

If a new operating program ("firmware") is successfully downloaded over-the-air the call will
complete as normal. Then the LEDs will rapidly flash in an alternating pattern for anywhere
between 10 – 30 seconds as the CNI2 reprograms itself. At the end of the operation the CNI2
will return to "sleep" mode and both LEDs will turn off.
CNI2 Operating and Installation Guide
DESCRIPTION
LED Error Codes 61 thru 79
107