Easy Connections - Pioneer DV-668AV Operating Instructions Manual

02 Connecting up

Easy connections

The setup described here is a basic setup that
allows you to play discs using just the cables
supplied with the player. In this setup, stereo
audio is played through your TV.
• This player is equipped with copy
protection technology. Do not connect
this player to your TV via a VCR using AV
cables, as the picture from this player will
not appear properly on your TV. (This
player may also not be compatible with
some combination TV/VCRs for the same
reason; refer to the manufacturer for
more information.)
1 Connect the VIDEO OUT and AUDIO
OUT (2ch) jacks to a set of A/V inputs on
your TV.
Use the supplied red/white stereo audio and
yellow video cable. Make sure you match up
the left and right audio outputs with their
corresponding inputs for correct stereo
sound.
14
En
TV
AUDIO AUDIO
OUT OUT
DIGITAL AUDIO
(2ch) (5.1ch)
OUT
SURROUND
FRONT
L
COAXIAL
L CENTER
R SUB
R
WOOFER
OPTICAL
S400
HDMI OUT
(AUDIO)
A/V IN
AV CONNECTOR 1 (RGB)-TV/AV Receiver
1 2
Y
1 2 P
IN OUT B
VIDEO S-VIDEO
CONTROL COMPONENT VID
OUT OUT
To power outlet
See Using other types of video output below if
you want to use a different type of connection.
• If you need another pair of stereo outputs
(and don't need to use the multichannel
analog outputs), you can use the AUDIO
OUT (5.1ch) FRONT L / R jacks (page 16).
2 Connect the supplied AC power cord
to the AC IN inlet, then plug into a power
outlet.
• Do not unplug the player from the power
outlet while it is switched on.
• Do not plug this player into a switched
power supply found on some amplifiers
and AV receivers.
AC IN
P
R