Checking The Tester's Version And Serial Number; If Something Seems Wrong - Fluke MicroScanner 2 User Manual

Checking the Tester's Version and Serial Number

Turn the tester on while holding down the
 
Use and to scroll through the screens:

  
: Software version

 
: Serial number

  
: Factory test date
To exit this mode, turn the tester off.
Symptom
The keypad does not respond.
The tester will not turn on.
Length measurements are incorrect.

If Something Seems Wrong

 
and keys.
If something seems wrong with the tester, refer to Table 2.
If Table 2 does not help you solve a problem with the tester,
contact Fluke Networks for additional help. If possible, have
the tester's version and serial number.
For warranty information, refer to the warranty at the
beginning of this manual. If the warranty has lapsed,
contact Fluke Networks for repair prices.
Table 2. Troubleshooting the Tester
Press and hold until the tester turns off; then turn the tester on again.

Replace the batteries, verifying that they are installed correctly. See Figure 28
on page 40.
Check the NVP value. See "Calibrating Length Measurements" on page 38.
If Something Seems Wrong
Action
41