Table of Contents
Advertisement
If you cannot locate the IntelliTone signal on
2-conductor cables, the cable may be shorted. Use
the tester to check for shorts. See pages 11 and 13.
Turn the probe's rotary switch to
7
Use the probe to isolate the tone source in the cable
8
bundle or at the patch panel. The SYNC LED lights up
green when the probe is receiving the IntelliTone signal.
The probe's LEDs light up from 1 to 8 as the signal
strength increases. The higher the number, the stronger
the signal.
Notes
(isolate).
Figure 24. IntelliTone Toner Mode Display
Using the Toner
egk07.eps
33
Hide quick links:
Advertisement
Table of Contents
