Using The Wiremap Adapter And Remote Id Locators - Fluke MicroScanner 2 User Manual

2
MicroScanner Cable Verifier
Users Manual
Using the Wiremap Adapter and Remote
ID Locators
Terminating twisted pair cabling with the standard
Universal adapter
wiremap adapter or optional remote ID locators lets the
(8-pin and 4-pin)
tester detect all types of wiremap faults. Without this
termination, the tester cannot detect crossed wires or
crossed pairs. For a wire pair with one wire open,
termination is required to detect which wire is open.
Remote ID
Without termination, the tester shows both wires as open.
locator
Using multiple remote ID locators helps you identify
8-pin or 4-pin
connections at patch panels. The tester shows the number
modular patch
of the locator connected to the far end of the cabling, as
cord
shown on page 23.
egk15.eps
To connect a remote ID locator to a modular (RJ) jack in a
Figure 4. Connecting a Remote ID Locator in a Confined
confined area or to a 4-pin modular jack (RJ11), use the
Area or to an RJ11 Jack
optional universal adapter and a patch cord, as shown in
Figure 4.
10