Accessories - Empire Heating Systems PVS18N-3 Owner's Manual And Installation Instructions

Part Number
PVSA1 Air Pipe Kit
PVSDV35A DV35 Vent Transition Cap
Part Number
PVSDS1 Deep Rear Shroud
PVSWS1 Wall Mount Shroud
Part Number
PVSHT2 Heated Humidification Tray
PVSEP2 External Condensate Pump
PVSCT10 Condensate Hose Extension
Part Number
PVSRT1 Temperature Sensor Relocation Kit
Notice: Following a power outage, this wall furnace will not automatically resume operation when operated manually or with
the internal thermostat. Once power is restored, the wall furnace will automatically power on in "Remote Mode" (--), and the
original operation settings will need to be re-entered. Installing an optional Millivolt thermostat control allows the wall furnace
to automatically resume operation under that thermostat's control once power is restored. Ask your dealer for details.
IMPORTANT
All correspondence regarding repair and service should
refer to complete Model Number, Serial Number and type
of gas.
Removing the Front Panel
It may become necessary to remove the front panel of the
appliance to remove dropped or fallen objects.
Remove the front panel by lifting up then pulling out. Re-
place the panel by reversing this step.
FOR YOUR SAFETY, TURN OFF POWER TO APPLIANCE.
Do not operate this appliance without the front panel.
37873-0-0217
INTRODUCTION

ACCESSORIES

Description
Description
Description
Description
WARNING
WARNING
ACCESSORIES
VENTING
Converts wall furnace from single flue to direct-vent (Comes standard with heater)
Replaces DV35 Vent cap with a transition to PVC pipe for a 2" single flue
SHROUDS
Allows venting to be run in front of the wall in on the floor installations
Allows installation of wall furnace off of the floor
CONDENSATE KITS
Evaporates condensate as humidity back into the room
Pumps condensate away from wall furnace instead of gravity drain
10 ft condensate drain extension
CONTROLS
Room Temperature Sensor Extension
Typical Uses
Typical Uses
Typical Uses
Features
Page 15