Siemens SIMATIC ET 200SP Manual page 30

Drivers, parameters, diagnostics messages and address space
A.3 Parameter assignment and structure of the module/channel parameters
Channel parameters
Each channel parameter block contains the cable parameters for the digital output (4 bytes).
The following figure shows the configuration of the channel parameters for channels 0 to 15.
x = 12 + (channel number * 2); with channel number 0...15
All unused bits and the bits or bytes marked as "reserved" must be set to zero.
You activate a channel parameter by setting the corresponding bit to "1" or the corresponding
value.
Figure A-3
30
Configuration byte x and x+1 for the channels 0 to 15
Digital output module DQ 16x24VDC/0.5A (6DL1132-6BH00-0PH1)
Manual, 05/2017, A5E39265993-AA