Figure 4-1 Data Capture Editing Field - Siemens SITRANS F Programming Manual

Special Notes for the Diagnostics Screen
1. If a flowmeter channel or path goes into "Fault" the [Meter Diagnostic] screen will display
2. SITRANS F 1010 operating system versions 3.01.06G and later were enhanced to
3. The format of the Data Capture file name will default to: [Site_Name Location_Name Date
Figure 4-1 Data Capture Editing Field
4. To accommodate gas industry standards, the displayed Flow Rate units and Sound
Si-Ware Quick Start
Programming Manual, 10/2011, A5E02951525-03
the fault code "F" in the Status field.
provide optimal performance when interfacing with Si-Ware, therefore you can expect the
older operating systems to update the diagnostic screen at a much slower rate.
Depending on the number of channels, and whether or not ZeroMatic is enabled, the
update rate may be 20 seconds or more with older SITRANS F 1010 operating systems.
Time.CSV] but can be edited and changed. This field can be easily overwritten if an
alternate file name is desired.
Note
Special Characters
If you perform a Data Capture function you can not create and name a Data Capture file
until you remove all the MS Windows special characters. The special characters it does
not allow to be used in file names are \ / : * ? " < > |
If you have any special characters in the site name they have to be edited in the [File
Name] edit box in the [Data Capture Function] screen section.
Velocity units may be different from the flowmeter units. For example: The flowmeter may
indicate KcuFt/hr, but Si-Ware will display this as MSCFH.
Note
The Meter Diagnostic screen will appear with the "Y" axis scaling menu on the left side of
the screen when the PC monitor resolution is less than 1024 x 768 pixels; however, all
functions are identical to the large screen example shown above.
Menu Screens
4.4 Diagnostics Menu
25