Siemens SITRANS F Programming Manual page 13

6. In the [Location / Tag#] data box type in a descriptive name for your flowmeter. This
7. When serial communication is completed "Connected" will appear at the bottom left of the
Si-Ware Quick Start
Programming Manual, 10/2011, A5E02951525-03
name should be something other than the flowmeter's SITE name since the site name,
date and time will be automatically appended to the Si-Ware Data Capture file name.
Press [OK].
Si-Ware screen and the [Connect] screen will close.
Note
If serial communication cannot be made, a pop-up error message will appear stating [No
Response from Meter] or if the meter responds incorrectly an [Expected Data Not
Received] error message will appear. If these messages appear then you should verify
proper communication settings at both the flowmeter and the Si-Ware program.
Note
The SITRANS F 1010 flowmeter must have at least one active site, channel or
measurement path that is not in Fault, otherwise the Si-Ware program will not function
beyond simply establishing communication with the flowmeter.
3.2 Si-Ware to Flowmeter Communications Setup
Connecting
11