Configuration Examples For Igmp State Limit; Configuring Igmp State Limiters Example - Cisco Catalyst 3850 series Configuration Manual

Configuration examples for IGMP State Limit

Command or Action
Example:
Device(config-if)# exit
Device(config-if)# end
Step 6 show ip igmp interface [type number]
Example:
Device# show ip igmp interface
Step 7 show ip igmp groups
Example:
Device# show ip igmp groups

Configuration examples for IGMP State Limit

Configuring IGMP State Limiters Example

The following example shows how to configure IGMP state limiters to provide multicast CAC in a network
environment where all the multicast flows roughly utilize the same amount of bandwidth.
This example uses the topology illustrated in the figure.
IP Multicast Routing Configuration Guide, Cisco IOS XE Release 3.6E (Catalyst 3850 Switches)
392
IP Multicast Optimization: IGMP State Limit
Purpose
(Optional) Displays information about the status and configuration
of IGMP and multicast routing on interfaces.
(Optional) Displays the multicast groups with receivers that are
directly connected to the device and that were learned through
IGMP.
OL-32598-01