Enabling Or Disabling Igmp Snooping On A Vlan Interface (Cli) - Cisco Catalyst 3850 series Configuration Manual

Configuring IGMP
DETAILED STEPS
Command or Action
Step 1
enable
Example:
Device> enable
Step 2
configure terminal
Example:
Device# configure terminal
Step 3 ip igmp snooping
Example:
Device(config)# ip igmp snooping
Step 4
bridge-domain bridge-id
Example:
Device(config)# bridge-domain 100
Step 5 ip igmp snooping
Example:
Device(config-bdomain)# ip igmp snooping
Step 6 end
Example:
Device(config-bdomain)# end

Enabling or Disabling IGMP Snooping on a VLAN Interface (CLI)

Follow these steps to enable IGMP snooping on a VLAN interface:
OL-32598-01
IP Multicast Routing Configuration Guide, Cisco IOS XE Release 3.6E (Catalyst 3850 Switches)
How to Configure IGMP Snooping
Purpose
Enables privileged EXEC mode.
• Enter your password if prompted.
Enters global configuration mode.
Globally enables IGMP snooping after it has been disabled.
(Optional) Enters bridge domain configuration mode.
(Optional) Enables IGMP snooping on the bridge domain
interface being configured.
• Required only if IGMP snooping was previously
explicitly disabled on the specified bridge domain.
Returns to privileged EXEC mode.
71