Configuring Non-Ip Wireless Multicast (Cli) - Cisco Catalyst 3850 series Configuration Manual

Configuring Non-IP Wireless Multicast (CLI)

Command or Action
Step 5
device-role {host | monitor | router | switch}
Example:
Device(config-nd-raguard)# device-role router
Configuring Non-IP Wireless Multicast (CLI)
SUMMARY STEPS
1. enable
2. configure terminal
3. wireless multicast non-ip
4. wireless multicast non-ip vlanid
5. end
DETAILED STEPS
Command or Action
Step 1 enable
Example:
Device> enable
Step 2
configure terminal
Example:
Device# configure terminal
Step 3 wireless multicast non-ip
Example:
Device(config)# wireless multicast non-ip
Device(config)# no wireless multicast
non-ip
Step 4 wireless multicast non-ip vlanid
Example:
Device(config)# wireless multicast non-ip
5
Device(config)# no wireless multicast
non-ip 5
IP Multicast Routing Configuration Guide, Cisco IOS XE Release 3.6E (Catalyst 3850 Switches)
252
Purpose
Sets the role of the device attached to the port.
Purpose
Enables privileged EXEC mode.
• Enter your password if prompted.
Enters global command mode.
Enables non-IP multicast in all VLANs. Default value is enable.
Wireless multicast must be enabled for the traffic to pass. Add no
in the command to disable the non-IP multicast in all VLANs.
Enables non-IP multicast per VLAN. Default value is enable. Both
wireless multicast and wireless multicast non-IP must be enabled
for traffic to pass. Add no in the command to disable the non-IP
multicast per VLAN.
Configuring Wireless Multicast
OL-32598-01