Front Panel - Interlogix ES3002-4P-4T User Manual

Maximum Frame Size
Flow Control
LED
DIP Switch
Dimensions (W × D × H)
Enclosure
Weight
Power requirements
Power consumption/ dissipation
Thermal fan
Power over Ethernet
PoE Standard
PoE Power Supply Type
PoE Power Output
Power Pin Assignment
PoE Power Budget
Max. Number of Class 2 PDs
Max. Number of Class 3 PDs
Max. Number of Class 4 PDs
Standards conformance
Regulatory compliance
Standards Compliance
2 / 8
9K bytes
IEEE 802.3x pause frame for full-
duplex
Back pressure for half-duplex
System:
Power (Green)
PoE max. (Green)
10/100/1000BASE-T RJ45
interfaces:
10/100Mbps LNK/ACT (Orange)
1000Mbps LNK/ACT (Green)
PoE interfaces:
PoE-in-Use (Orange)
Selectable operation mode
• Standard
• Extended
135 × 87 × 32 mm
Metal
929 g
AC 100~240 V, 50/60 Hz, 2A max.
Max. 65 W/223 BTU
None
IEEE 802.3af Power over
Ethernet/PSE
IEEE 802.3at Power over Ethernet
Plus/PSE
End-span
Per port 53 VDC, 600 mA.
max. 30 W
1/2(+), 3/6(-)
60 W
4
4
2
FCC Part 15 Class A, CE
IEEE 802.3 10BASE-T
IEEE 802.3u 100BASE-TX
IEEE 802.3ab Gigabit 1000BASE-T
IEEE 802.3x flow control and back
pressure
IEEE 802.3af Power over Ethernet
IEEE 802.3at Power over Ethernet
Plus
IEEE 802.3az Energy Efficient
Ethernet (EEE)
Environment
Operating
Storage
Description
These switches provide three different running speeds
(10 Mbps, 100 Mbps, and 1000 Mbps), and automatically
distinguish the speed of the incoming connection.
For easier management and control of the gigabit Ethernet
switch, become familiar with its display indicators and ports.
Front panel illustrations in this section show the unit LED
indicators. Read this section carefully before connecting any
network device to the gigabit Ethernet switch.

Front panel

The front panel of the gigabit Ethernet switch consists of eight
auto-sensing 10/100/1000Mbps Ethernet RJ45 ports. The LED
indicators are also located on the front panel of the gigabit
Ethernet switch.
Figure 1: ES3002-4P-4T front panel
The front panel of the gigabit Ethernet switch provides one DIP
switch for "Standard" and "Extended" mode selections.
Detailed descriptions are shown in the following table.
DIP switch mode Function
Standard
Numbers 1 to 4 correspond to PoE Port-1 to
Port-4.
In this mode, the gigabit Ethernet switch
operates as a general switch and all PoE
ports operate at 10/100/1000Mbps auto-
negotiation.
(default)
Extended
In this mode, the gigabit Ethernet switch PoE
ports operate at auto–negotiation 10Mbps
speed duplex mode only, but the delivery
distance of PoE power and network data can
reach 200 m.
Temperature: 0 ~ 50°C
Relative Humidity: 5 ~ 95% (non-
condensing)
Temperature: -10 ~ 70°C
Relative Humidity: 5 ~ 95% (non-
condensing)
P/N 1073337-EN • REV A • ISS 19JUL17