Switching The Information Display - Olympus E-M10 Mark III Instruction Manual

Switching the information display

You can switch the information displayed in
the monitor during shooting using the INFO
button.
S-IS ON S-IS ON
P
INFO INFO
S-IS ON S-IS ON
P
Level Gauge display
* Not displayed in n mode (movie mode) unless recording is in progress.
• You can change Custom1 and Custom2 settings. g [G/Info Settings] > [LV-Info]
(P. 110)
• The information display screens can be switched in either direction by rotating the dial
while pressing the INFO button.
Histogram display
A histogram showing the distribution of brightness
in the image is displayed. The horizontal axis
gives the brightness, the vertical axis the number
of pixels of each brightness in the image. During
shooting, overexposure is indicated in red,
underexposure in blue, and the range metered
using spot metering in green.
Level gauge display
The orientation of the camera is indicated. The "tilt" direction is indicated on the vertical bar
and the "horizon" direction on the horizontal bar. The camera is level and plumb when the
bars turn green.
• Use the indicators on the level gauge as a guide.
• Error in the display can be corrected via calibration (P. 114).
Wi-Fi
INFO INFO
ISO-A
200
L N
FHD F
30p
1:02:03
250 F5.6 250 0.0
1023
Basic Information*
Wi-Fi
INFO INFO
ISO-A
200
1:02:03
250 250 F5.6 0.0
1023
(Custom2)
INFO button
Image Only
Wi-Fi
S-IS ON S-IS ON
ISO-A
200
1:02:03
P 250 250 F5.6 0.0
1023
Histogram display
(Custom1)
More
Less
Dark
INFO INFO
Bright
EN
2
23