Adjusting The Picture Quality - Sony ZRD-1 Operating Instructions Manual

Adjusting the Picture
Quality
Adjust the contrast, brightness, and other picture quality
settings.
The settings configured on the primary controller will be
applied to all the other display controllers, including the
sub controllers. Sub controllers cannot be configured
individually.
Caution
If the a primary controller is not configured via Display
Control Software or the primary controller is not already
turned on at the time the [Picture Settings] screen is
displayed, picture quality adjustment cannot be performed.
In addition, the picture quality settings will not be applied
to the sub controllers if they are not turned on.
1
Select [Picture Settings] in the [Array] menu on the
main screen of Display Control Software.
2
Configure each setting.
The values currently configured on the primary
controller are displayed on the [Picture Settings]
screen.
The settings are reflected in the picture immediately
after they are configured.
[Contrast]: Use the slider and
the contrast.
Setting range: 0 to 100
Default value: 60
[Brightness]: Use the slider and
adjust the brightness.
Setting range: 0 to 100
Default value: 50
3
4
buttons to adjust
buttons to
11
[Gamma]: Select the gamma correction value.
Default value: 2.2
Caution
This product is not a medical device. The device
cannot be used for medical examinations, even
when [DICOM SIM] is selected.
[Color Space]: Select the color space.
• [Native (Default)]: Display the picture using
the original color space that is input.
• [sRGB]: Display the picture using the sRGB
color space standard.
• [AdobeRGB]: Display the picture using the
Adobe RGB color space standard.
• [DCI]: Display the picture using the DCI color
space standard.
• [BT.2020]: Display the picture using the
BT.2020 color space standard.
Caution
[AdobeRGB], [DCI], and [BT.2020] do not
include the entirety of the color spaces defined by
their respective standards.
[Color Temperature Setting]: Select the color
temperature in [Color Temperature].
• If you selected [D93], [D65], or [D50], proceed
to step 4 .
• If you selected [D93 Custom (Offset)], [D65
Custom (Offset)], or [D50 Custom (Offset)],
proceed to step 3 .
Configure the offset values.
These settings can only be configured when [Color
Temperature] is set to "Custom (Offset)" in step 2 .
Use the slider and buttons to adjust the contrast.
Setting range: –128 to +127
Default value: 0
When you are finished configuring settings, click
[Close].