Displaying 3D Video - Sony ZRD-1 Operating Instructions Manual

Displaying 3D Video

Note
In this document, the signals for the left and right eyes are
referred to as the L and R signals respectively.
For details, refer to the Installation Manual.
For mixed L/R signals (frame sequence mode):
Video signal inputs from the DisplayPort connector are
output to the display unit. 3D sync signal inputs from the
3D SYNC IN connector are output from the 3D SYNC
OUT connector according to the picture output's timing.
For separated L/R signals (3D dual input mode):
Video signal inputs from the DisplayPort connectors (L
from DP 1 and R from DP 2) and the DVI connectors (L
from DVI 1 and R from DVI 3) are mixed (L/R) and output
to the display unit.
Internally generated 3D sync signals are output from the
3D SYNC OUT connector according to the picture
output's timing.
Select [3D Settings] in the [Array] menu on the main
screen of Display Control Software to display the [3D
Settings] screen.
[3D Dual Input Mode]: Leave this checkbox cleared if
the signal input from the DisplayPort connector is a
mixed L/R signal (100/120 Hz). Select the checkbox
if L (50/60 Hz) and R (50/60 Hz) are separated in the
input signal.
[3D Dual Input 4K Mode]: Clear this checkbox for 3D
video other than 4K.
[3D Sync Signal Invert Mode]: Select this checkbox to
invert the L and R signals.
[3D Sync Signal Delay]: Use the slider or
adjust the phase (when 3D video is not displayed
properly). Moving the slider also changes the number
value. Clicking [Default] restores the default value.
Note
Inversion and phase adjustments can be configured for
both mixed L/R and separated L/R. The settings are
reflected in the picture immediately after they are
configured.
buttons to
12