Ntp Commands; Display Ntp-Service Sessions - HP FlexFabric 12500 Series Network Management And Monitoring Command Reference

NTP commands

display ntp-service sessions

Use display ntp-service sessions to display information about all IPv4 NTP associations.
Syntax
display ntp-service sessions [ verbose ]
Views
Any view
Predefined user roles
network-admin
network-operator
mdc-admin
mdc-operator
Parameters
verbose: Displays detailed information about all IPv4 NTP associations. If you do not specify this
keyword, the command displays only brief information about the NTP associations.
Usage guidelines
When a device is operating in NTP broadcast or multicast server mode, the display ntp-service sessions
command does not display the IPv4 NTP association information corresponding to the broadcast or
multicast server, but the associations are counted in the total number of associations.
Examples
# Display brief information about all IPv4 NTP associations.
<Sysname> display ntp-service sessions
source
********************************************************************************
[12345]LOCAL(0)
[5]0.0.0.0
Notes: 1 source(master), 2 source(peer), 3 selected, 4 candidate, 5 configured.
Total sessions: 1
Table 13 Command output
Field
source
reference stra reach poll
LOCL
INIT 16
Description
•
When the reference clock is the local clock, the field displays LOCAL
(number), which indicates that the IP address of the local clock is
127.127.1.number, where number represents the NTP process number in the
range of 0 to 3.
•
When the reference clock is the clock of another device, the field displays
the IP address of the NTP server. If this field displays 0.0.0.0, the IP address
of the NTP server has not been resolved successfully.
84
now offset
0 1 64 - 0.0000 0.0000 7937.9
0 64 - 0.0000 0.0000 0.0000
delay disper