Monitor Kernel Starvation Time - HP FlexFabric 12500 Series Network Management And Monitoring Command Reference

Inappropriate use of this command can cause service problems or system breakdown. Make sure you
understand the impact of this command on your network before you use it.
This command is supported only on the default MDC.
Examples
# Disable kernel thread starvation detection for kernel thread 15.
<Sysname> system-view
[Sysname] monitor kernel starvation exclude-thread 15
Related commands
display kernel starvation
•
• display kernel starvation configuration

monitor kernel starvation time

•
monitor kernel starvation enable
•
monitor kernel starvation time
Use monitor kernel starvation time to set the interval for identifying a kernel thread starvation.
Use undo monitor kernel starvation time to restore the default.
Syntax
In standalone mode:
monitor kernel starvation time interval [ slot slot-number ]
undo monitor kernel starvation time [ slot slot-number ]
In IRF mode:
monitor kernel starvation time interval [ chassis chassis-number slot slot-number ]
undo monitor kernel starvation time [ chassis chassis-number slot slot-number ]
Default
The interval for identifying a kernel thread starvation is 120 seconds.
Views
System view
Predefined user roles
network-admin
Parameters
time interval: Specifies the interval for identifying a kernel thread starvation, in the range of 1 to 65535
seconds.
slot slot-number: Specifies an MPU by its slot number. If you do not specify this option, the active MPU is
specified. (In standalone mode.)
chassis chassis-number slot slot-number: Specifies an MPU on an IRF member device. If you do not
specify this option, the global active MPU is specified. (In IRF mode.)
291