Write Serial Number From Pc Mode: Required On The Production Line; Print From Pc Mode: Required On The Production Line; Other Inspection Tools: <Usb Port Wiping Tool For Pt-D600: Qm Inspection Use Only - Brother PT-D600 Service Manual

3.20 Write Serial Number from PC Mode:
Required on the Production Line
Be sure to provide power supply of DC12.0V ±0.1V / DC9.0V ±0.1V [Insert resistant
1Ω ±5% (2W and more)] for the inspection from DC power or AA battery.
This mode is used to write serial number of the machine by connecting your PC with
an USB cable.
Connect your PC in normal editing mode, and run the dedicated program.
Last 9 digits of the serial number (G1J497693 if the serial number is E60125-
G1J497693) which was scanned by bar code scanner will be written in the FROM of
the machine.
Do not turn OFF the machine during the serial number writing.
[ON/OFF] key becomes invalid during the data writing into FROM.

3.21 Print from PC Mode: Required on the Production Line

Be sure to provide power supply of DC12.0V ±0.1V / DC9.0V ±0.1V [Insert resistant
1Ω ±5% (2W and more)] for the inspection from DC power.
This mode is used to perform PRINT 1 from PC connected with an USB cable.
Refer to <Figure
3.22 Other Inspection Tools:
<USB Port Wiping Tool for PT-D600: QM Inspection use only>
Service space: Production factory
Supported OS: Windows 7
Function: Deletes all the PT-D600 relevant USB ports in PC.
Driver for PT-D600 will be used after the mass production trail.
3.8-3> for print sample. Supported tape width is only 24 mm.
III - 46