Factory Inspection Mode ([1] To [6], [9] And [T] Keys) - Brother PT-D600 Service Manual

3.3 Factory Inspection Mode ([1] to [6], [9] and [T] Keys)

This mode is for shipping inspection at factories.
[1] to [6] and [9] keys are always enabled except for when inspecting keys, rotating
motors, displaying
4> or displaying "NG" in the writing and starting inspection for CUT mode, in message
check mode, in each parameter setting mode, and displaying error message ("!" on
the screen).
Other keys are enabled when
If any error (ex. cover open) occurs while printing, press any key except the any key
to return to the beginning of the inspection.
Specifications for European/North American models
Key
[1]
Write Setting Mode
[&]
[2]
INFORMATION Mode
[é]
[3] Inspect Cassette/Color
["] Sensor Switch Mode
[4]
Inspect Key Mode
[']
[5] PRINT 1 Mode
[)] (30 mm/sec)
[6]
Full CUT Mode
[-]
[7]
PRINT 2 Mode
[è]
[8] PRINT 1 Mode
[!] (20 mm/sec)
[9]
AD Check Mode 2
[ç]
[M] Motor Rotation Mode
Serial Number Check
[N]
Mode
[S] Checksum Check Mode
<Figure 3.4-2> in the setting writing mode, displaying
<Figure 3.2-1> is displayed.
Inspection
Mode
at factory
(Shipping
tool)
III - 20
Power
supply at
inspection
DC power
All
or battery
DC power
All
or battery
DC power
All
or battery
DC power
All
or battery
DC power
All
or battery
-
DC power
or battery
DC power
-
or battery
- Battery
All Battery
- -
- -
- -
<Figure 3.4-
Automatically
shift Remarks
inspection to
-
[2]
-
[3]
Print the
setting of
[4]
cassette
attachment
[5] -
[8] -
Use the
cleaning
tape
Printing will
Power OFF
be
inoperable
after this
mode
- -
[6] -
- -
- -
- -
- -