Table Of Contents; Warnings - Cisco IE 4010 Hardware Installation Manual

Switch Installation
Read the topics and perform the procedures in this order:

Warnings, page 13

Installation Guidelines, page 14

Verifying Switch Operation, page 14

Installing the Switch, page 15

Installing and Removing SFP Modules, page 26

Replacing the SD Flash Memory Card, page 30

Connecting Devices to the Ethernet Ports, page 31

Where to Go Next, page 32

Warnings

These warnings are translated into several languages in the Regulatory Compliance and Safety Information for the Cisco
IE 4010 Switch document.
These warning statements apply to all the switches:
Warning: Before working on equipment that is connected to power lines, remove jewelry (including rings,
necklaces, and watches). Metal objects will heat up when connected to power and ground and can cause serious
burns or weld the metal object to the terminals. Statement 43
Warning: Read the installation instructions before you connect the system to its power source. Statement 1004
Warning: This unit is intended for installation in restricted access areas. A restricted access area can be accessed
only through the use of a special tool, lock and key, or other means of security. Statement 1017
Warning: This equipment must be grounded. Never defeat the ground conductor or operate the equipment in the
absence of a suitably installed ground conductor. Contact the appropriate electrical inspection authority or an
electrician if you are uncertain that suitable grounding is available. Statement 1024
Warning: This unit might have more than one power supply connection. All connections must be removed to
de-energize the unit. Statement 1028
Only trained and qualified personnel should be allowed to install, replace, or service this equipment. Statement
Warning:
1030
Warning: Ultimate disposal of this product should be handled according to all national laws and regulations.
Statement 1040
Warning: For connections outside the building where the equipment is installed, the following ports must be
connected through an approved network termination unit with integral circuit protection.
10/100/1000 Ethernet Statement 1044
Cisco Systems, Inc. www.cisco.com
13