North American Hazardous Location Approval; Emc Environmental Conditions For Products Installed In The European Union - Cisco IE 4010 Hardware Installation Manual

Hazardous Location Installation Information
Hazardous Area Installation Warnings
Warning: Use twisted-pair supply wires suitable for 86°F (30°C) above surrounding ambient temperature outside
the enclosure. Statement 1067
Warning: When used in a Class I, Division 2, hazardous location, this equipment must be mounted in a suitable
enclosure with a proper wiring method that complies with the governing electrical codes. Statement 1069
Warning: Explosion Hazard—The area must be known to be nonhazardous before installing, servicing, or replacing
the unit. Statement 1082
Note: This equipment has been tested by UL for the explosion, fire, shock and casualty hazards required by the
applicable hazardous locations standards. UL certification does not cover the performance or reliability of any GPS
hardware, GPS operating software, or other GPS-related aspects of equipment covered under this category.
Accordingly, UL makes no representations, warranties or certifications regarding the performance or reliability of any
GPS-related functions of equipment covered under this category.

North American Hazardous Location Approval

The following information applies when operating this equipment in hazardous locations:
English: Products marked "Class I, Div 2, GP A, B, C, D" are suitable for use in Class I Division 2 Groups A,
B, C, D, Hazardous Locations and nonhazardous locations only. Each product is supplied with
markings on the rating nameplate indicating the hazardous location temperature code. When
combining products within a system, the most adverse temperature code (lowest "T" number)
may be used to help determine the overall temperature code of the system. Combinations of
equipment in your system are subject to investigation by the local Authority Having Jurisdiction at
the time of installation.
Français: Informations sur l'utilisation de cet équipement en environnements dangereux:
Les produits marqués "Class I, Div 2, GP A, B, C, D" ne conviennent qu'à une utilisation en
environnements de Classe I Division 2 Groupes A, B, C, D dangereux et non dangereux. Chaque
produit est livré avec des marquages sur sa plaque d'identification qui indiquent le code de
température pour les environnements dangereux. Lorsque plusieurs produits sont combinés dans
un système, le code de température le plus défavorable (code de température le plus faible) peut
être utilisé pour déterminer le code de température global du système. Les combinaisons
d'équipements dans le système sont sujettes à inspection par les autorités locales qualifiées au
moment de l'installation.

EMC Environmental Conditions for Products Installed in the European Union

This section applies to products to be installed in the European Union.
The equipment is intended to operate under the following environmental conditions with respect to EMC:

A separate defined location under the user's control.

Earthing and bonding shall meet the requirements of ETS 300 253 or CCITT K27.

AC-power distribution shall be one of the following types, where applicable: TN-S and TN-C as defined in IEC
364-3.
In addition, if equipment is operated in a domestic environment, interference could occur.
50