Table of Contents
Advertisement
SmartPicture
You can make the picture softer or sharper or
distinct the picture when playing back the tape.
SmartPicture is set to AUTO when you receive the
VCR.
1
Select SmartPicture Mode
1 Press VCR.
2 Press SMARTPICTURE
button. The current setting will
appear on the screen for about
5 seconds.
3 While the current setting
appears, press the SMART-PICTURE button
repeatedly, the setting changes as follows.
AUTO:
Normally select this mode.
DISTINCT:
Select this mode when you want the distinct
picture. The picture detail is emphasized.
SOFT:
Select this mode when you want the soft
picture. The signal noise of the picture is
softened.
SHARP:
Select this mode when you want the sharp
picture. The picture edge is emphasized.
Notes:
• It is recommended that the SmartPicture is set to
"SOFT" if playback picture is noisy.
• When "DSPC" is set to "OFF", "AUTO" is switched
to "NATURAL" automatically.
DSPC
The DSPC (Digital Studio Picture Control) system
checks the condition of the tape in use during
recording and playback, and compensates to
provide the highest possible recording and playback
pictures. Set the DSPC to "ON" or "OFF" on the
VCR Set Up menu.
1
Select VCR Set Up Mode
1 Press VCR.
2 Press MENU.
5
3 Press PLAY
or STOP
to select "VCR SET UP" then
press OK/STATUS.
AUTO
DSPC
ON
ON SCREEN MODE
ON
∞
TIMER REC SPEED
MANUAL
AUDIO OUT
HIFI
AUDIO SAT
RECORD LINK
OFF
TAPE LIST
ON
SELECT:
CHANGE:
END: MENU
2
Select DSPC
5
1 Press PLAY
or STOP
3
2 Press FF
to set "ON" or "OFF".
3
Finish Setting
Press MENU.
Once the "DSPC" mode is set to "ON", the DSPC
system works for both recording & playback;
appears blinking on the display.
Notes:
• The DSPC system works for SP, LP and SLP modes only
after a tape has been inserted and the Record mode is
first initiated. Also, it works if the colour mode is
changed. It does not work during recording.
• In the case of timer recording, the DSPC system works
before recording is initiated.
• Once the cassette is ejected after recording, the DSPC
data is cancelled. The next time the cassette is used for
recording, DSPC is re-performed.
• When "DSPC' is displayed, the VCR does not start One
Touch Recording.
• Since the DSPC system works before recording actually
starts, there is a delay of approximately 7 seconds after
REC/OTR
is pressed. To make sure you record the
desired scene or programme in its entirety, first perform
the following steps:
1) Press and hold STILL/SLOW
8
on the front panel) and press REC/OTR
engage the RECORD PAUSE mode.
• The VCR then automatically checks the condition of the
tape and, after approximately 7 seconds, re-enters
RECORD PAUSE.
2) Press REC/OTR
• If you want to bypass the DSPC system and begin
recording immediately set "DSPC" to "OFF".
• The VCR adjusts the playback picture quality based on
the quality of the tape in use.
• When watching a tape recorded with "DSPC" set to
"ON", it is recommended that you leave DSPC to
"ON" during playback as well.
• "DSPC" only appears at the beginning of automatic
tracking. Even though it doesn't appear after that, the
DSPC function is operative.
10
∞
to select "DSPC".
(or PAUSE/STILL
again to start recording.
to
Advertisement
Table of Contents
