Storing The Camera Status (Preset Function); Recalling Stored Status; Changing The Speed Of Movement Between Positions - Sony RM-IP500 Operating Instructions Manual

Storing the Camera
Status (Preset Function)
The camera status, comprising the camera position,
zooming, focusing, backlighting compensation, flicker
compensation, and white/black balance adjustments,
can be stored in the memory of the camera.
You can set the speed of movement between positions
for preset memory operation using OPERATION
>PRESET in the RM menu. This setting is applied to all
presets.
The speed of movement default setting is 24.
The number of presets varies depending on the camera.
For details, refer to the specifications for the camera.
1
Direct recall
Number
6 7
recall
1
Press the ACTIVE buttons, turning them on
(buttons are lit), on the joystick control block and
preset memory control block.
2
Select the camera whose status you want to store.
For details about selection, see "Selecting a
Camera" (page 27).
3
Operate the joystick to pan/tilt the orientation of the
camera.
4
Perform zoom, focus, backlight compensation,
flicker compensation, and white/black balance
adjustments, as required.
5
Check that the DIRECT RECALL button is off.
Turn it off if it is currently turned on.
6
Enter the preset number you want to store.
Use the PRESET 10/0 button to enter a "0" digit.
Preset numbers in the range 1 to 100 can be set.
7

Recalling stored status

There are two methods for recalling stored status: direct
recall and number recall.
3 1 Direct recall
With the DIRECT RECALL button on (button is lit
yellow), press the PRESET 1 to PRESET 10/0 buttons to
recall preset numbers 1 to 10.
Only preset numbers 1 to 10 can be recalled using direct
recall.
Number recall
With the DIRECT RECALL button off (button is not
lit), enter the preset number using the PRESET 1 to
PRESET 10/0 buttons, in the same way as when storing
a preset, and then press the RECALL button.
In this method, the entered preset number is displayed at
the bottom right on the LCD panel of the menu control
block.
Preset numbers 1 to 100 can be recalled using number
recall.
Changing the speed of movement
between positions
1
2
3
4
34
The preset number is displayed at the bottom right
on the LCD panel of the menu control block.
Press and hold the STORE button.
The camera status is stored in the memory of the
camera.
The preset number at the bottom right of the LCD
panel disappears, and storing is completed when
the STORE button becomes lit.
After registering a preset, we recommend that you
check that the camera status is stored correctly by
recalling the preset.
Check that the DIRECT RECALL button is off.
Turn it off if it is currently turned on.
Select a camera, and recall the position you want to
change.
Set the speed using OPERATION >PRESET
>SPEED in the RM menu.
Press and hold the STORE button.