Controlling The Volume; Operating Non-Preset Components - Learning Function; Programming A Component Signal - Sony RM-VZ950T Operating Instructions Manual

Controlling the volume

To control the volume of an
audio component (CD, MD, TAPE)
Press 2 +/– to control the
volume, and
amplifier.
Example
When you press 2 +/– at "CD,"
you can control the volume of the
amplifier.
You can change this setting also
(page 15).
To control the volume of a
visual component (SAT, VCR,
DVD)
Press 2 +/– to control the
volume, and
Example
When you press 2 +/– at "VCR,"
you can control the volume of the
TV.
You can change this setting also
(page 15).
Note
If you have programmed any signal on
the 2 +/– or
"AMP" using the Learning function
(page 15), that signal will not be
transmitted when you control other
components. To use "learned" signals,
you need to program the 2 +/– or
buttons for each component using the
Learning function.
to mute on the
to mute on the TV.
button for "TV" or
Operating Non-Preset
Components
— Learning Function
To operate non-preset components
or functions, use the following
Learning procedure to "teach" any
of the programmable buttons to
operate the functions of another
remote control. You can also use
the Learning function to change
the signals of individual buttons
after setting the component code
number.
It is recommended that you make
a note of the "learned" function
controls.
Note
Some specific remote control signals
may not be "learned."
Programming a component
signal
Jog
dial
2
Continued
15
GB