Sony RM-IP500 Operating Instructions Manual page 16

Connecting remote controllers, cameras, and setup PC using LAN connection
Connection example
MODE LAN RS-232C RS-422
VISCA
RM-IP10
Setup PC
Remote control signal: LAN cable (category 5 or higher)
Tally/contact signal: Connection cable with D-sub 15-pin connectors
Video signal: HDMI cable
Video signal: Connection cable with BNC connectors
Signal flow
*1 For an example connection with a video switcher, see "Connection with a video switcher" (page 24).
*2 Use a connection cable designed for the switcher being used. For the specifications of the GPI I/O connector of
the unit, see "Pin assignments" (page 52).
*3 To connect the BRC-H900 using a LAN connection, a BRBK-IP10 IP control card must be installed. In addition,
use an IP control card with firmware version 2.1 or later.
1
Connect the LAN connector of the units and LAN
connector of the cameras using LAN cables.
You can connect up to 100 cameras and five remote
controllers on the same network.
2
To configure setting of the unit and cameras using
setup software, connect a PC to the same network.
• Use shielded-type LAN cables to prevent
malfunction that may result from radiation noise.
• Use a LAN cable (category 5 or higher).
RM-IP500
BRBK-IP10 IP
control card
!
Switching hub
Video monitor
*2
BRC-H900
1 2 3
1 2 3 4 5 6 7 8 9
IR SELECT
VISCA RS-422 OFF ON HD SD
RGB/COMPONENT
75
IN VISCA RS-232 OUT EXT SYNC IN VIDEO S VIDEO SDI OUT
1 2 DATA MIX
BRBK-IP10
OFF
ON
HD SD
LAN SDI OUT
*3
BRC-X1000,
BRC-H800
IR SELECT CAMERA SETUP
1 2 3
SYSTEM IN VISCA RS - 422 OUT LAN
SELECT
OSD
ON OFF
HDMI OUT MONITOR OUT LINE OUT
EXT SYNC IN
SDI 1 SDI 2 SDI 1 SDI 2
SRG-360SHE
RAUD RATE MIC VISCA RS-422
R L
(PLUG IN POWER)
SYSTEM
SELECT HDMI OUT SDI OUT
• Connect the cameras, remote controllers, and PC
via switching hubs (10BASE-T or 100BASE-
TX). Use on a network with significant packet
loss or delay may cause a malfunction. Use a
high-quality network.
• Do not mix 10BASE-T and 100BASE-TX in the
network.
• The IP address of the unit is set to 192.168.0.10,
and the IP address of a camera and BRBK-IP10
16
DC IN 12V
*1
Video switcher
12V
TERMI-
NATION
ON OFF
IR SELECT
LAN
*2