Extron electronics System 5 IP Series Setup Manual page 24

im Vertrieb von
System 5 IP Software Setup, cont'd
5. In the upper left corner drop-down menu (under
DVD & VCR Control), select Input 4, as illustrated below.
This assigns the input button (Input 4) to activate the
IRCM-DV+ [DVD] control panel.
Input 4 button selection
6. Click the Auto Fill button.
N
To use the Auto Fill feature, an applicable IR driver must
be present.
A dialog box appears.
Control module configuration
7. From the Auto Fill Dual-Function DVD and VCR IR
Control Module dialog box, select the Hitachi DV-PF7E
DVD/VCR IR driver. All functions for the selected driver
appear in the right side pane of the dialog box.
8. Select Port A from the bottom portion of the dialog box.
9. Click the OK button. The dialog box closes.
www.camboard.de
3-18 System 5 IP Switchers • Software Setup
CAMBOARD Electronics
Step 8: Create a Dsplay Shutdown Schedule
Tel. 07131 911201
Fax 07131 911203
All commands that match a button on the module are
assigned to that button. Red triangles on the buttons of the
control module indicate that all the matching buttons have
been auto-filled.
10. To configure Address 2 IRCM-DV+[VCR], repeat steps 1
through 9, substituting Address 2 for Address 1.
N
In step 5, you will need to select a different input button in
the VCR half of the control module.
N
If using an IRCM-DV+, you must associate each half with
an input.
Global Configurator's scheduling feature enables you to
schedule actions and events for a selected device. Scheduling
is often useful for setting a projector or other device to shut
down or turn on at a predetermined time (e.g., in a school, all
projectors can be set to power off at 5:00 P.M.).
To schedule a display shutdown:
1. Click on the Schedule tab in the Global Configurator
window.
2. Click the Add Schedule button below the Scheduled
Actions window. The Scheduled Actions Wizard dialog
box appears, as shown below.
Scheduled Actions Wizard
ce-info@camboard.de
System 5 IP Switchers • Software Setup 3-19