Storage; Maintenance - Stamina 1764 Owner's Manual

STORAGE

1. To store the 1764 Magnetic Elliptical Trainer, simply keep it in a clean dry place.
2. The minimum rest dimensions of the 1764 Magnetic Elliptical Trainer are approximately 53.3 inches
long x 25.5 inches wide x 66.8 inches tall. These dimensions may vary. Please measure your 1764
Magnetic Elliptical Trainer if exact dimensions are needed.
3. To move the 1764 Magnetic Elliptical Trainer, lift the back end of the REAR BASE(2) and use the
wheels which built in the FRONT STABILIZER(80).
4. To avoid damage to the electronics, remove the batteries before storing the 1764 Magnetic Elliptical
Trainer for one year or more.

MAINTENANCE

The safety and integrity designed into the 1764 Magnetic Elliptical Trainer can only be maintained
when the 1764 Magnetic Elliptical Trainer is regularly examined for damage and wear. Special attention
should be given to the following:
1. Adjust the TENSION KNOB(38) and verify that the resistance changes.
2. Verify that all nuts and bolts are present and properly tightened. Replace missing nuts and bolts.
Tighten loose nuts and bolts.
3. Verify that the WARNING LABEL(98) is in place and easy to read. Call Stamina Products immediately
at 1-800-375-7520 for a replacement WARNING LABEL(98) if it is missing or damaged.
4. It is the sole responsibility of the user/owner to ensure that regular maintenance is performed.
5. Worn or damaged components shall be replaced immediately or the 1764 Magnetic Elliptical Trainer
removed from service until repair is made.
6. Only Stamina Products supplied components shall be used to maintain/repair the 1764 Magnetic
Elliptical Trainer.
7. Keep your 1764 Magnetic Elliptical Trainer clean by wiping it off with an absorbent cloth after use.
16